Installation Guide SMT 2200/3000 VA
Input/Output Hardwire Kit
Safety
Adhere to all national and local electrical codes. A certified electrician must perform all electrical
connections.
1. Disconnect equipment connected to the UPS.
2. Press the OFF button located on the front of the UPS.
3. Disconnect the batteries in the UPS.
4. Disconnect the UPS from utility power.
NOTE: When removing the panels from the UPS, note which cable is connected to the AC input. There are two
4-pin connectors on the UPS and they are not interchangeable.
Inventory
Note: The illustrations in this document may differ slightly from the actual hardware.
Terminal block
4 grounding screws
8 screws
secure input, output, and
blank panels to the UPS
2 wire nuts
Terminal block label
2 screws secure the
terminal block to the UPS
Input panel
Output panel
Blank panel
Secure the terminal block and label to the UPS
Hardwire Kit SMT2200/3000 VA 100/120/230 VAC Tower
3
Connect the terminal block and UPS connectors as shown in the diagram.
NOTE: The two pin connector will not be utilized with the replacement input and output panels.
AC Input
Connector
AC Input
Connectors
Secure the blank panel to the UPS with three
screws (supplied).
APC Worldwide Customer Support
Customer support for this or any other APC product is available at no charge in any of the following ways:
• Visit the APC Web site to access documents in the APC Knowledge Base and to submit customer
support requests.
Connect to localized APC Web sites for specific countries, each of which provides customer
support information.
Global support searching APC Knowledge Base and using e-support.
• Contact the APC Customer Support Center by telephone or e-mail.
For information on how to obtain local customer support, contact the APC representative or other distributors from whom
you purchased your APC product.
4
Hardwire Kit SMT2200/3000 VA 100/120/230 VAC Tower
© 2011 APC by Schneider Electric. APC, the APC logo, and Smart-UPS are owned by Schneider
Electric Industries S.A.S., American Power Conversion Corporation, or their affiliated companies.
All other trademarks are property of their respective owners.
990-3933
6/2011
|