Xserve, Xserve G5, Xserve RAID
Hard Drive
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Online instructions covering customer-installable parts are available at
Note: Blank drive carriers, which may fill some of the hard drive bays, follow the same
replacement procedure as hard drives. If you are replacing a blank carrier with a drive
module, be sure to keep the blank for possible future use. Blank drive carriers must be
installed in all empty drive bays to maintain proper airflow through the unit. Be careful not
to apply excessive pressure when installing the blank carriers.
Tools Required
No tools are required for this procedure.
Preliminary Steps
Xserve/Xserve G5 includes one to four drive bays, and Xserve RAID includes fourteen
drive bays for Apple Drive Modules. The modules consist of hard drives attached to
carriers; they are removed from or installed in the server as a unit.You can replace hard
drives while the system is running; you do not need to shut down or open the unit first.
Note: There are two LED indicators on the front of each drive.
• The upper LED (Xserve) or right LED (Xserve RAID) shows drive status: a green light
indicates the drive is good; a yellow or red light indicates the drive should be replaced
or removed and reinserted.
• The lower LED (Xserve) or left LED (Xserve RAID) shows drive activity: when the light
is blinking, the system is reading from or writing to the drive. To avoid losing data,
never remove a drive when the lower or left LED is blinking.
1. If the hard drives are in the locked position (the yellow security LED on the front panel
is on), use the Allen key that came with the system to unlock them.
WARNING: Drives must be in the unlocked position before you attempt to remove a
drive. If the drives are locked, pulling on the drive to remove it could damage the
drive handle.
2. Wait for the lower or left LED on the front of the drive to stop blinking.
073-0666 Rev. E
Installing the Replacement Hard Drive
1. Press the handle on the front of the replacement drive module so that the handle pops
out.
2. Place your fingers on the center of the drive faceplate directly below the handle. Push
the drive into the empty bay until its connector clicks into place.
3. Press in the handle on the drive module so that it is flush with the front panel.
4. Wait for the upper or right LED to turn green, indicating normal operation.
Apple Computer, Inc.
© 2004 Apple Computer, Inc. All rights reserved.
This document is protected under U.S. Copyright Law and International Treaties, and no
part of this document may be reproduced in any form without written permission from
Apple.
Apple is not responsible for typographical, printing, or inadvertent errors.
Apple Computer, Inc.
1 Infinite Loop
Cupertino, CA 95014-2084
USA
+ 1 408 996 1010
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple
Computer, Inc., registered in the U.S. and other countries. Xserve is a trademark of Apple
Computer, Inc.
Xserve, Xserve G5, Xserve RAID Hard Drive - 3
|