ON OPERATION
NOTES ON “
”
COMPACT DISC PLAYER
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded with
high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of
the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged
when the peak level of the sound is played. The lens on the disc table should be kept clean. Do not touch
the lens or poke at it. If you do so, the lens may be damaged and the unit will not operate properly.
•
•
During playback (batteries are in use), “
When the battery voltage level is low, “
continues in this period.
” is off.
” will flash for approx. 10 ~15 minutes, playback still
OPERATING INSTRUCTIONS
•
•
Playback would automatically come to a stop when the batteries have no more power. Do not repeatedly
Before using the unit, please read this manual thoroughly and retain it for future reference.
press “ ” button as the unit may operate incorrectly. Replace all the batteries with new ones.
” will not be on when an AC adaptor is used.
“
Notes:
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, THE CD PLAYER AND AC/DC
ADAPTOR DO NOT EXPOSE TO RAIN OR MOISTURE.
•
The normal function of the product may be disturbed by interference and shows error message, just
reconnect the power source for resume normal operation.
USING ON HOUSE CURRENT
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
If the unit you purchased does not include an AC power adaptor, please use a 6V 350mA AC power
adaptor. Plus pole “ ” to the centre pin of the 5.5 mm socket.
•
The CD player and adaptor shall not be exposed to dripping or splashing water and that no objects
filled with liquids, such as vases, shall be placed on the apparatus.
When the unit is not used, be sure to disconnect the AC power adaptor.
ON INSTALLATION
CAUTION
Never install the unit where it would be subject to:
FUNCTION OF CONTROLS
-
-
-
-
-
-
heat sources such as radiators or airducts.
direct sunlight.
excessive dust.
moisture or rain.
mechanical vibration or shock.
uneven surface.
The use of optical instruments with this product will increase eye hazard.
STOP
INFORMATION (FOR THE CUSTOMERS IN USA)
Press once for disc playing stops.
Press twice for power off.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
•
•
Do not place any heavy object on top of the unit.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Track search and fast forward / fast reverse
SKIP -
When the unit is used with an AC power adaptor, do not wrap the unit in a cloth, blanket, etc. If
you do so, the temperature inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit or serious accidents.
Press “
To locate the beginning of the current selection or previous selections.
Keep “ ” depressed:
” lightly / repeatedly:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, If not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
•
If the unit is brought directly from a cold to a warm location, or is placed in a very damp room,
moisture may condense on the lens inside the unit. Should this occur, the unit will not operate.
In this case, remove the disc and leave the unit in a warm place for several hours until
the moisture evaporates.
To go back at high speed(search).
SKIP +
For the unit to operate at its best, it should not be subject to temperatures below 5o C (41o F) or
above 35o C (95o F).
Press “
To locate the beginning of next selection / selections.
Keep “ ” depressed:
” lightly / repeatedly:
-
-
-
-
Reorient or relocate the receiving antenna.
NOTES ON HEADPHONES / EARPHONES
To go ahead at high speed (search).
Increase the separation between the equipment and receiver.
Connecttheequipmentintoanoutletthatisonacircuitdifferentfromtheonethereceiverisconnected.
Consult the dealer or an experienced radio / TV technician for help.
Do not use headphones / earphones while driving, cycling, or operating any motorized vehicle, it may
create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your
headsets at high volume while walking, especially at pedestrian crossings. You should exercise caution
or discontinue use in potentially hazardous situations.
Avoid using headphones / earphones at high volume. Hearing experts advise against continuous, loud
and extended play. If you experience a ringing in your ears, reduce volume or discontinue use.
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate
to the people around you.
PLAY/PAUSE
Press “
Press “
” to begin play.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
” during play to pause.
To release pause, press “
” again.
Complies with the Canadian ICES-003 class B specification.
PROG
Program
Playing the selections in the desired order.
Button for selecting the various play mode.
FOR THE CUSTOMERS IN THE UNITED KINGDOM AND / EUROPEAN COUNTRIES
If you have any questions or problems concerning your unit, please consult your nearest dealer.
MODE
This compact disc player is classified as a CLASS 1 LASER
product.
NOTES:
Opening the CD tray.
To insert or remove a disc.
PUSH OPEN
The CLASS LASER PRODUCT label is located on the bottom
exterior.
•
•
•
This unit can play Audio Discs including CD-Recordables and CD-Rewriteables. Do not try to play
CD-ROMs, CD-ls, CDVs, or computer CDs.
The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-
R/RW recorders because of differences in recording platforms.
Do not attach any seal or label to either side(the recordable side or the labled side) of a CD-R/RW
disc. It may cause malfunction.
VOLUME
Adjust the volume level.
FOR THE CUSTOMERS IN CANADA
This apparatus complies with the Class B limits for
CAUTION
radio noise emissions set out in radio interference
INVISIBLE LASER RADIATION
regulations.
This product contains a low power laser device.
•
•
Do not use irregular shape CDs(example: heart-shaped, octagonal ones). It may result in malfunction.
When a CD-RW is loaded, it takes about 15 seconds before it can be play-back.
PHONES
PHONES jack
For connecting the headphones / earphones.
WHEN OPEN AND INTER.
LOCKS DEFEATED.
AVOID EXPOSURE TO BEAM.
Mains socket
POWER SOURCES
USING WITH BATTERIES
PRECAUTIONS
Insert two size AA batteries (LR6 or MN1500 alkaline) according to the “ ” and “ ” marks correctly
aligned.
ON SAFETY
NOTES ON BATTERIES
As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble
the casing. Refer servicing to qualified personnel only.
Do not put any foreign objects in the safety slot inside the disc compartment. If you do so, the laser beam
may come out when the lid is opened.
Do not put any foreign objects in the DC IN 6V (external power input) jack. Should any solid objects or
liquid fall into the unit, disconnect the power supply and have the unit checked by qualified personnel
before operating it any further.
•
•
•
Insert batteries with correct polarity.
Do not use old batteries together with new ones or different types of batteries together.
If the electrolyte inside the battery should leak, wipe the contaminated parts in the battery compartment
with a cloth and replace the old batteries with new ones.
•
•
When the unit is not used for a long period of time, remove the batteries.
Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM)
batteries.
|