Please read this manual thoroughly before operating your new CD player.
IMPORTANT NOTES
Avoid installing the unit in locations described below.
•
Places exposed to direct sunlight or close to heat radiating appliances such as electric
heaters.
•
•
•
•
On top of other stereo equipment that radiates too much heat.
Places lacking ventilation or dusty places.
Places subject to constant vibration.
Humid or moist places.
MODEL #JX-CD339
This product utilizes a laser.
Danger - invisible laser radiation is present when unit is opened and interlock failed or
defeated.
Caution - Use of the controls or adjustments of procedures other than those specified herein
may result in hazardous radiation.
PERSONAL COMPACT DISC PLAYER
THIS LASER COMPACT DISC PLAYER FUNCTIONS BY HELP OF INVISIBLE LASER
LIGHT AND IS EQUIPPED WITH SAFETY SWITCHES TO AVOID EXPOSURE WHEN
DOOR IS OPEN AND SAFETY INTERLOCKS ARE DEFEATED. IT IS DANGEROUS TO
DEFEAT OR BY PASS SAFETY
SWITHCES.
INSTRUCTION MANUAL
EN-1
CHARGING AND USE OF RECHARGEABLE BATTERIES
Rechargeable Battery Operation
POWER SOURCES NORMAL BATTERIES / AC ADAPTOR
Battery Power Operation
AC Adaptor Operation
(DC 4.5V 500mA AC adaptor
not supplied )
1. Open the battery compartment
cover and insert two “AA”
alkaline batteries inside the
battery compartment. Follow
the polarity as indicated in the
battery compartment.
This unit can fully recharge the specified rechargeable battery, in approximately
15 hours. The rechargeable batteries (NOT supplied) should be recharged before
they are used form the first time because they are low in power or if they have not
been used for a long period (over 60 days)
1. Insert the DC plug, at the
end of the AC adaptor cord
into the DC input socket, at
the back of the unit.
1.Open the battery compartment cover and insert two of the recommended
rechargeable batteries, matching polarity. (1.2V 650mA)
2. Close the battery compartment
cover.
2. Plug the AC adaptor into a
AC power outlet socket.
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM OR
NI-MH TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.
2. Plug in the AC adaptor (DC 4.5V 500mA) and set the Recharge switch to ON
position to start charging. During charging the RED LED charge indicator will
illuminate.
3. After 15 hours. Please unplug the AC adaptor and switch the Recharge switch to
the OFF position.
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO
CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES
TO DETERIORATE.
Note: When the unit is to be
operated using batteries, always
unplug the AC adaptor from the AC
power outlet and the DC input socket
from the set. Otherwise the player
will not operate.
Note: You may play DISC'S whilst charging the batteries.
4. If the operating time decreases drastically even when the rechargeable batteries
are properly recharged, purchase a new set of rechargeable batteries.
5. When charging for the first time or after a long time, playing time may be reduced.
In this case, charge and discharge the batteries several times.
3. (a) Do not mix old and new
batteries.
(b) Do not mix alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
4. If the unit is not to be used for an
extended period of time, remove
the batteries. Old or leaking
batteries can cause damage to
the unit and may void the
warranty.
EN-4
EN-5
HEADPHONE AND HI FI CONNECTION
BASIC DISC PLAY
1. Connect the Headphones to the
ꢀ Listening with the
NOTE: This player plays not only
commercial CDs but also
ꢀ Connecting to component
PHONES ( GREEN ) socket.
2. Slide the OPEN switch to open the
CD compartment lid.
3. Adjust the VOLUME to minimum.
4. Insert the disc with the label side
facing up.
5. Close the lid securely until a click
is heard.
6. Press the PLAY button to start
playing.
headphones
audio systems
self-compiled CD-R/RW disc.
Connect the plug of the stereo
headphones ( included ) into the
PHONES ( GREEN ) socket.
Connect the stereo connection
cable ( not included ) into the
LINE OUT ( BLACK ) socket of
the unit and the CD / AUX inputs
of an audio system.
6
Caution: Avoid excessive volume
levels for a long period of time when
using headphones, as this may
impair your hearing.
Note: Always switch the power off
before making any connections
between the player and another unit.
1
3
2
7. Adjust VOLUME for desired level.
Caution:
5
Avoid excessive volume levels while
listening to sound for a long period of
time when using headphones.
4
TO CD/AUX
INPUT
To Emphasize the bass sound
Set the DBBS switch to the ON
position.
Note: The bass boost performance
will be dependent on the VOLUME
control setting.
Remove the disc
Hold the edge and gently press the
center pivot as illustrated, then pick
up the disc.
Turning Power on and off
This unit has no ON / OFF switch.
To turn on and off, press the
following buttons.
To turn on : Press
PLAY/PAUSE
( playback starts )
To turn off : Press
STOP button
once for standby mode.
Press STOP button
again to turn off the power.
TO PHONES SOCKET
TO LINE OUT SOCKET
Caution:
Wait for the disc to stop rotating before
pressing the OPEN button.
Note:
This unit can play 3 inch ( 8cm ) single
CD’s without an adaptor. Do not use a
CD single adaptor for these discs.
Auto power-off function
When the unit is stopped (standby
mode ) for approximately 1 minute, the
power is automatically turned off.
EN-6
EN-7
LCD DISPLAY INFORMATION
During STOP mode
REPEAT / PLAY MODES
Every time the MODE button is pressed, the corresponding mode appears in the
display window, in the following sequence:
The total number of tracks of the disc is
displayed.
NORMAL
REPEAT 1
REPEAT ALL
Total no. of tracks.
During PLAY mode
The track number is displayed.
MODE
INTRO
NOTE: In normal mode none of the above symbols show in the display.
This fifth track.
NORMAL PLAYBACK
Press once to play
During PAUSE mode
When the track playback is paused, the track
Play the whole disc.
press
number flashes.
PLAY/PAUSE
REPEAT 1
During play
Shown in the LCD display.
Note:
The current track on the disc
will be repeated.
When the lid is opened during play mode " - - " shows in the display indicating
the door is open.
press
REPEAT ALL
MODE
Note:
A flashing battery indicator
be changed or recharged.
appears in the display when the batteries need to
Shown in the LCD display.
All tracks on the disc will be
During play
repeated.
x2 press
MODE
EN-8
EN-9
INTRO SCAN AND RANDOM PLAY
PROGRAMMED PLAY AND SEARCH FUNCTIONS
PROGRAM
INTRO
This allows selected tracks on the disc to be played in any desired order.
Plays the first 10 second of each track on the disc.
To set the program play
Programs can be set in PLAY or STOP mode.
During playback
1. Press the PROG button.
X3
MODE
Press
The track number will appear in the display with
PGM
the
indicator flashing.
or to select the desired track.
2. Press
When in the STOP mode press the MODE button three times and then
press the PLAY/PAUSE button to start INTRO playback.
3. Press the PROG button to enter the track into
the memory.
4. Repeat step 2 and 3 to program up to 24 tracks
memory.
During disc playback press the MODE button three times and then press
the back skip
button to start INTRO playback. Alternatively INTRO will start
5. Press
to start the programmed play.
at the end of the current playing track.
6. To erase the program, press the STOP button once.
RANDOM
Locating a Particular track
Enables all the tracks on a disc to be played in a Random ( RAND ) sequence.
To skip back to the beginning of the
Press
lightly and repeatedly.
lightly and repeatedly.
current or a previous track
For example : If "RAND" is selected while playing track 8, the random function
will commence once track 8 has ended.
When all tracks on a disc have been played the player will automatically stop
and power down in approx. 1 minutes to preserve battery life.
To skip to the beginning of the following
Press
tracks
During play
Locating a Particular Point in a track
X1press
RAND
To search backward at a high speed
To search forward at a high speed
Keep
Keep
depressed
depressed
Press RAND button again to return to the NORMAL play mode.
Note: Low level audio will be heard during the search process to assist in
locating correct point in the track.
EN-11
EN-10
TROUBLESHOOTING GUIDE
PLAYER MAINTENANCE
Cleaning the Cabinet
Troubleshooting Guide
Points to Check
Wipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak
solution of neutral detergent and water, and then wipe clean.
Problem
Cleaning the Lens
Disc may be inserted upside down
Disc not mounted correctly on chuck
Dirty or defective disc
A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not
work. Open the disc cover and clean the lens as follows:
Dirty pick up lens
Player lid not closed
Player fails to function
Dust or Dry Particles
Moisture/Condensation, allow player to warm up to
room temperature for 60 minutes
AC power to adaptor switched off
Weak batteries
Using a camera lens brush/blower, blow on the
lens a couple of times, then wipe it lightly with
he brush to remove dust. Then, blow on the
lens once more.
Auto switch off has occurred
Finger prints
Headphone plug is not firmly inserted into the
Green Phones socket.
Headphones have been inserted into the Black line
output socket.
No sound from
Headphones
If the lens cannot be cleaned by using a brush / blower,
use a dry cotton swab starting in the middle and working to the outside edge.
No sound when played
through an external
amplifier
Connection is incorrect
Cleaning the Disc
Power to external amplifier not switched on
When a disc becomes dirty, clean it
with a cleaning cloth. Wipe the disc
from the centre out.
Dirty or defective disc
Dirty pick up lens
Player is subject to excessive vibration or shock
Low battery power
Poor Headphone connection
Intermittent sound
Note:
Do not use solvents such as benzine petrol, thinner, commercially available
cleaners or anti-static spray intended for analogue discs.
EN-13
EN-12
|