Series 2000 10-cup filter coffee maker
Two year guarantee
THIS GUARANTEE IS VALID IN THE UK AND
IRELAND ONLY. It is in your interest to retain the
retailers receipt as proof of purchase. Please quote the
following information if the product develops a fault.
These numbers can be found on the base of the product.
To qualify for the 2 year guarantee the appliance must
have been used according to the manufacturers
instructions. For example kettles should have been
regularly descaled or an iron cord should have been
stored as recommended by the instructions.
Model No.
Serial No.
EXCLUSIO NS
Morphy Richards shall not be liable to replace or
repair the goods under the terms of the Guarantee where:
All Morphy Richards Products are individually tested
before leaving the factory. In the unlikely event of any
appliance proving to be faulty within 28 days of purchase it
should be returned to the place of purchase for it to be
replaced.
If the fault develops after 28 days and within 24
months of original purchase, you should contact the
helpline number quoting Model number and Serial number
on the product, or write to the address below. You will
be asked to return the product (in secure, adequate
packaging) to the address below along with a copy of proof
of purchase. Subject to the exclusions set out below (see
‘Exclusions’) the faulty appliance will then be repaired or
replaced and dispatched usually within 7 working days of
receipt.
1
The fault has been caused or is attributable to
accidental use, mis-use, negligent use or used contrary
to the manufacturers recommendations or where the
fault has been caused by power surges or damage
caused in transit.
2
3
4
5
6
The appliance has been used on a voltage supply other
than that stamped on the products.
Repairs have been attempted by persons other than
our service staff (or authorised dealer).
Where the appliance has been used for hire purposes
or non-domestic use.
Morphy Richards are not liable to carry out any type of
servicing work, under the guarantee.
Plastic filters and glass jugs for all Morphy Richards kettles
and coffee makers are not covered by the guarantee.
This guarantee does not confer any rights other than
If for any reason this item is replaced during the 2 year
guarantee period, the guarantee on the new item will be
calculated from original purchase date. Therefore it is vital
to retain your original till receipt or invoice to indicate the
date of initial purchase.
those expressly set out above and does not cover any
claims for consequential loss or damage. This guarantee is
offered as an additional benefit and does not affect your
statutory rights as a consumer.
The After Sales Division, Morphy Richards Ltd, Mexborough, South Yorkshire, England, S64 8AJ
Helpline (office hours): UK (local rate) 08450 777700, Republic of Ireland 1800 409119
Electrical requirements Features
Check that the voltage on the rating plate of
Hinged
your appliance corresponds with your house
electricity supply which must be A.C. (Alternating
Current).
If the socket outlets in your home are not
suitable for the plug supplied with this appliance,
the plug should be removed and the appropriate
one fitted.
reservoir
lid with
strength
selector
Removable
permanent mesh filter
W ARNING: The plug removed from the
mains lead, if severed, must be destroyed as a
plug with bared flexible cord is hazardous if
engaged into a live socket outlet.
W ARNING: THIS APPLIANCE MUST
BE EARTHED
Removable
filter holder
Should the fuse in the 13 amp plug require
replacement, a BS1362 13 amp fuse must be
fitted.
Non-drip valve
Jug lid
Glass jug with water
level indicator
Hot plate
Water level indicator
Neon on/off switch
The first time you use your coffee maker
Before using your coffee maker the first time,
operate the coffee maker with water only.
3
General use
1 Lift up the hinged reservoir lid.
2 Fill the glass jug with
6 Slide the jug into the coffee maker ensuring it
sits correctly on the hot plate. The jug lid
m ust be in place during the brewing
process, otherwise the non-drip valve
will not open, causing the filter to flood.
7 Plug the coffee maker in at the wall socket and
switch the coffee maker ON. The switch will
light up to show the coffee maker is working.
8 Hot water will start to flow through the coffee
grounds and into the glass jug as coffee.
9 When the coffee has been made, serve as
required. The anti-drip valve will prevent any
remaining coffee dripping onto the hot plate.
Ensure that the jug is replaced on the hotplate
after serving. While the coffee maker is
switched ON the hot plate will keep the coffee
warm.
the required amount of cold water and pour
into the reservoir. Both the jug and water
level indicator are marked in cups. Do not
exceed the maximum level.
10 Switch off the coffee maker when the jug is
empty or the coffee is no longer required.
W ARNING THE CO FFEE MAKER AND
HO T PLATE ARE HO T AND REMAIN
HO T FO R SO ME TIME AFTER
SW ITCHING O FF.
11 Remove the permanent mesh filter using its
handle and empty the used coffee grounds.
Wash the filter immediately and dry
thoroughly. NOTE: THE MESH WILL
BECOME DISCOLOURED AFTER A WHILE
DUE TO THE STAINING EFFECT OF
COFFEE.
Refilling
Switch off the coffee maker and allow
3 minutes to cool before refilling with cold water.
3 Spoon the required amount of ground filter
coffee into the mesh filter spreading it evenly.
We suggest one level dessert spoon for every
1
/
1 2 cups. Ensure the filter is sitting properly in
the filter holder.
4 Close the reservoir lid.
5 Select the strength of coffee required using
the strength selector on the reservoir lid.
4
4
Descaling
Cleaning care
If you live in a hard water area, we
UNPLUG CO FFEE MAKER AND
recommend that your coffee maker is descaled at ALLO W TO CO O L.
regular intervals, e.g. every 2-3 months. In areas
of moderately hard water you should descale
every 6 months.
If the water filters through more slowly than
usual, it is a sign that descaling is necessary.
We recommend you use proprietary liquid
descaler which is especially made for coffee
DO NO T IMMERSE THE CO FFEE
MAKER IN LIQ UID.
Rinse the water reservoir occasionally with
cold water. Don’t use a cloth as any residue or
lint may be left behind to clog the coffee maker.
Remove the permanent filter, discard used
coffee and wash. Extended soaking helps to
makers and plastic kettles. Follow the instructions remove coffee stains from the mesh.
on the bottle, and then operate the coffee maker
with water only 3 times before making coffee.
DO NOT USE KETTLE DESCALER UNLESS
THE PACKET SPECIFICALLY STATES IT IS
SUITABLE FOR COFFEE MAKERS. The
permanent mesh filter should not be used during
descaling.
Wash the glass jug, jug lid and filter holder in
warm soapy water. Rinse and dry all parts
thoroughly. Re-fit filter and filter holder.
Care must be taken to ensure that non-drip
valve situated on bottom of filter holder is not
damaged during cleaning.
Wipe all external surfaces including hot plate
with a damp cloth and dry thoroughly.
NEVER USE HARSH OR ABRASIVE
CLEANERS.
5
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design.
The Company, therefore, reserves the right to change the specification of its models at any time.
Morphy Richards Lim ited, Mexborough,
South Yorkshire, England S64 8AJ
447/8015/05 RevOI August 2000
6
|